Abstract
Abstract The Monte Carlo Wielandt method has the potential to eliminate most of a variance bias because it can reduce the dominance ratio by properly controlling the estimated eigenvalue ( k e ). However, it requires increasingly more computation time to simulate additional fission neutrons as the estimated eigenvalue becomes closer to the effective multiplication factor ( k eff ). Therefore, its advantage over the conventional Monte Carlo (MC) power method in the calculation efficiency may not always be ensured. Its efficiency of the tally estimation needs to be assessed in terms of a figure of merit based on a real variance as a function of k e . In this paper, the real variance is estimated by using an inter-cycle correlation of the fission source distribution for the MC Wielandt calculations. Then, the tally efficiency of the MC Wielandt method is analyzed for a 2 × 2 fission matrix system and weakly coupled fissile array problems with different dominance ratios (DRs). It is shown that the tally efficiency of the MC Wielandt method depends strongly on k e , there is a k e value resulting in the best efficiency for a problem with a large DR, and the efficiency curve as a function of L, the average number of fission neutrons per history, follows a long tail after the best efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.