Abstract
AbstractThe main scope of the presented work is to demonstrate the potential of load optimized tubes with a varying thickness distribution in circumferential direction produced by roll forming. As initial material a so called Tailor Rolled Strip (TRS) sheet metal coil produced by Strip Profile Rolling (SPR) method was used instead of plain sheet. The TRS sheet metal is manufactured in a continuously working process by rolling one or more groves in transverse direction into the sheet metal coil. In this paper, the secondary forming of the TRS sheet metal to TRS tubes is investigated by means of FE‐simulations and roll forming experiments. To simulate the manufacturing process of the TRS tube by FEM, an integrated consideration of the process is necessary because of the large local strain hardening in the groves of the initial SPR sheet metal. In experimental roll forming operations welded tubes could be manufactured successfully. The geometrical and material properties of these tubes are analyzed. The reprocessing of TRS tubes by hydroforming is investigated by means of tube bursting tests. It has been found that an additional annealing process is necessary to achieve deformations in the grooved area during the hydroforming process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.