Abstract
The paper presents the results of a systematic study of the influence of nano-additives of various concentrations, average sizes and composition on the temperature dependence of the viscosity and rheological behavior of water-based drilling fluids. Typical compositions of drilling fluids, such as water suspensions of various clay solutions and gammaxan-based polymer solutions, were considered. Hydrophilic nanoparticles of silicon and aluminum oxides were used as nano-additives at concentrations ranging from 0.25 to 3 wt%. The average nanoparticle size varied from 10 to 151 nm. The temperature of drilling fluids varied from 25°C to 80°C. It is shown that the addition of nanoparticles to drilling fluids leads to a significant change in their rheological properties depending on the temperature. It was found that with increasing temperature, the yield stress and consistency index of drilling fluids with nanoparticles increase, while the behavior index, on the contrary, decreases. This behavior depends on the size of the nanoparticles. As the particle size increases, their influence on the temperature dependence of the drilling fluids’ viscosity increases. In general, it is shown that the addition of nanoparticles makes the viscosity of drilling fluid more stable with regard to the temperature. This is an essential fact for practical application.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.