Systematic comparison of structural and lipid oxidation in oil-in-water and water-in-oil biphasic emulgels: effect of emulsion type, oil-phase composition, and oil fraction.

Abstract

Because many common foods are emulsions (mayonnaise, margarine, salad dressing, etc.), a better understanding of lipid oxidation is crucial for the formulation, production, and storage of the relevant consumer products. We prepared oil-in-water (O/W) and water-in-oil (W/O) emulgels, and their architecture was characterized before monitoring lipid oxidation under thermally accelerated conditions to systematically compare the effect of emulsion type, oil composition, and oil fraction on the structure and lipid oxidation in thee biphasic emulgel systems. Higher susceptibility of lipids to oxidation (>2.5 times) was observed in the biphasic O/W and W/O emulgels than in soybean oil owing to an interfacial region. In the heterogeneous emulsion systems, W/O emulgels had oxidation resistance than O/W emulgels did. Compared with the oil-phase composition of high oleic sunflower, soybean, and flaxseed oils, oxidation sensitivity of emulsified lipids was significantly raised as the degree of unsaturation increased from 100.72 to 203.07. Moreover, increasing oil fraction from 75% to 85% led to an obvious increase in total oxidation in O/W emulgels but a decrease in W/O emulgels. In addition to emulsion size and oil unsaturation, viscoelasticity had a remarkable effect on the low-unsaturated oil oxidation (e.g. high oleic sunflower oil). Physical and structural phenomena played important roles in lipid oxidation based on a mass transport principle. These findings provide novel information for designing the structures of emulsion gels for controlling lipid oxidation through the cooperation of both formulation and architecture principles. © 2022 Society of Chemical Industry.