System zones in capillary zone electrophoresis.

Abstract

This paper brings an overview of system zones (SZs) in capillary zone electrophoresis (CZE) and their effects upon the migration of zones of analytes. It is shown that the formation and migration of SZs is an inherent feature of CZE, and that it depends predominantly on the composition of an actual background electrolyte (BGE). One can distinguish between stationary SZs and migrating SZs. Stationary SZs, which move due to the electroosmotic flow only, are induced in any BGE by sample injection. Migrating SZs may be induced by a sample injection in BGEs which show at least one of the following features: (i) BGE contains two or more co-ions, (ii) BGE has low or high pH whereby H+ or OH- act as the second co-ion, and (iii) BGE contains multivalent weak acids or bases. SZs do not contain any analyte and show always BGE-like composition. They contain components of the BGE only and the concentrations of these components are different from their values in the original BGE. Providing that some of the ionic components of the BGE are visible by the detector, the migrating SZs can be detected and they are present as system peaks/dips in the electropherogram. It is shown that a migrating SZ may be characterized by its mobility, and examples are given how this mobility can depend on the composition of the BGE. Further, the effects of the migrating SZs (either visible or not visible by the detector) upon the zones of analytes are presented and the typical disturbances of the peaks (extra broadening, zig-zag form, schizophrenic behavior) are exemplified and discussed. Finally, some conclusions are presented how to cope with the SZs in practice. The proposed procedure is based on the theoretical predictions and/or measurements of the mobilities of SZs and on the so-called unsafe region. Then, such operational conditions should be selected where the unsafe region is outside of the required analytical window.