Synthetic CT for gamma knife radiosurgery dose calculation: A feasibility study

Abstract

PurposeTo determine if MRI-based synthetic CTs (sCT), generated with no predefined pulse sequence, can be used for inhomogeneity correction in routine gamma knife radiosurgery (GKRS) treatment planning dose calculation. MethodsTwo sets of sCTs were generated from T1post and T2 images using cycleGAN. Twenty-eight patients (18 training, 10 validation) were retrospectively selected. The image quality of the generated sCTs was compared with the original CT (oCT) regarding the HU value preservation using histogram comparison, RMSE and MAE, and structural integrity. Dosimetric comparisons were also made among GKRS plans from 3 calculation approaches: TMR10 (oCT), and convolution (oCT and sCT), at four locations: original disease site, bone/tissue interface, air/tissue interface, and mid-brain. ResultsThe study showed that sCTs and oCTs’ HU were similar, with T2-sCT performing better. TMR10 significantly underdosed the target by a mean of 5.4% compared to the convolution algorithm. There was no significant difference in convolution algorithm shot time between the oCT and sCT generated with T2. The highest and lowest dosimetric differences between the two CTs were observed in the bone and air interface, respectively. Dosimetric differences of 3.3% were observed in sCT predicted from MRI with stereotactic frames, which was not included in the training sets. ConclusionsMRI-based sCT can be utilized for GKRS convolution dose calculation without the unnecessary radiation dose, and sCT without metal artifacts could be generated in framed cases. Larger datasets inclusive of all pulse sequences can improve the training set. Further investigation and validation studies are needed before clinical implementation.