Abstract
In the present study biodegradable, environmentally friendly polysaccharide-based polycarboxylate, carboxymethyl inulin (CMI), was used to produce hydroxyapatite (HAP) particles by wet chemical synthesis under controlled temperature, pH, and atmospheric conditions. The morphology and microstructure of the HAP nanoparticles were investigated by XRD, SEM, DTA–TGA and FTIR. CMI affects morphology, surface area, dimension and particle size distribution of the crystals. The reduction in size is greater in the direction of the c-axis. The increase in the polymer concentration to 7.5g/L resulted in the mixture of nanoparticles with particle sizes of less than 100nm. The SEM micrograph shows the formation of well-crystallized, agglomerated small particles of HAP. X-ray analysis has shown that the resulting particles have high thermal stability.The obtained crystals were used to produce tablets by direct compression of HAP. The influence of sample's CMI concentration on drug release profiles was investigated by using ibuprofen (C13H18O2) as a model drug. The model was used to determine the effective diffusion coefficient of the drug from the tablets. A good agreement between experimental data and model predictions was obtained as calculated in the present work. The values of the diffusion coefficients range from 1.62×10−7 to 4.72×10−7m2h−1.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.