Abstract

A seven-step approach was developed to synthesize poly(acrylic acid-b-2-hydroxyethyl methacrylate) [P(AA-b-HEMA)]-based temperature- and pH-sensitive hollow nanospheres. Silica nanoparticles were used as primary cores that could be etched with an aqueous hydrofluoric acid (HF) solution. A surface-attached atom transfer radical polymerization initiator was converted to a reversible addition–fragmentation chain transfer (RAFT) agent, and AA and HEMA were polymerized via “grafting from” RAFT polymerization. The PAA block was cross-linked partially via an esterification reaction with -COOH groups with 1,4-butanediol, and hollow nanospheres were obtained by etching silica cores with an aqueous HF solution. These hollow nanospheres exhibited dual pH-sensitive and thermosensitive properties as measured by the hydrodynamic diameter at different values of pH (3–12) and temperature (25–55 °C) at different concentrations (1 and 5 mg/mL). Results showed that this behavior could be changed at different concentrations; therefore, at low contents, the particles show one lower critical solution temperature (LCST), while at higher contents, two LCSTs are observed.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.