Synthesis of aspartame precursor: α‐L‐aspartyl‐L‐phenylalanine methyl ester in ethyl acetate using thermolysin entrapped in polyurethane

Abstract

Cross-linked polyurethane (PU) was prepared for entrapping thermolysin. Using the immobilized thermolysin (IT), Z-L-aspartic acid (ZA) was reacted with -Lphenylalanine methyl ester (L-PM) in water-saturated ethyl acetate to give only alpha-Z-L-aspartylL-phenylalanine methyl ester (alpha-ZAPM). Ninety-four percent conversion of alpha-ZAPM was obtained for 30 h of reaction at 40 degrees C when 46 mg of enzyme was entrapped. PU support prepared from polypropylene glycol (#2000) showed better properties than from polypropylene (#1000) and polyethylene (#1000). Addition of polyol could increase the gel fraction of PU. The IT PU-ll-G-3, prepared from 1/2 mole ratio of PPG (#2000)/glycerin, gave the highest gel fraction and best swelling, and 89.0% of residual activity was obtained after four times of reuse (72 h). The stability of immobilized thermolysin was good; the activity loss resulting from degradatin and leak of enzyme in each time of reuse were found only about 2%. The kinetics of immobilized thermolysin-catalyzed condensation reaction of ZA with L-PM in water-saturated ethyl acetate was found to be first order in L-PM and the Lineweaver-Burk plot of 1/V against 1/[ZA] yields a straight line, showing that the reaction involves consecutive reactions of ZA and L-PM with the immobilized enzyme and with the ZA-immobilized enzyme complex, with the second reaction being the rate determining step.