Abstract
Starting from 1,3-dimethyl-4-imidazoline-2-selone (1), 1,2-bis(2-selenoxo-3-methyl-4-imidazolinyl-2-)ethane (3) and 1,3-dimethylimidazolidine-2-selone (4), the following six compounds, [(C(5)H(8)N(2)Se-)(2)](2+).2Br(-) (I), [(C(5)H(8)N(2)Se-)(2)](2+).2I(-) (II), [(C(5)H(8)N(2)Se-)(2)](2+).Cl(-).I(3)(-) (III) [(C(5)H(10)N(2)Se-)(2)](2+).Br(-).IBr(2)(-) (IV), [(C(5)H(7)N(2)Se-)(2)](2+).I(3)(-).(1)/(2)I(4)(-) (V) and [(C(5)H(7)N(2)Se-)(2)](2+).2I(-).CH(3)CN (VI), in which the selenium compounds are oxidized to dications bearing the uncommon -Se-Se- bridge, have been prepared, and I-V crystallographically characterized. I and III were obtained by reacting 1 with IBr and ICl respectively, while II was obtained by reduction of previously described hypervalent selenium compound of 1 (5) bearing the I-Se-I group with elemental tellurium. These three compounds contain the same [(C(5)H(8)N(2)Se-)(2)](2+) dication balanced by two bromides in I, two iodides in II, and Cl(-) and I(3)(-) in III. However, on the basis of the Se-Cl bond length of 2.778(5) Å, III can also be considered as formed by the [(C(5)H(8)N(2)Se-)(2)Cl](+) cation, with I(3)(-) as counterion. Similarly to III, compound IV, which was obtained by reacting 4 with IBr, can be considered as formed by [(C(5)H(10)N(2)Se-)(2)Br](+) cations and IBr(2)(-) anions. As in II, compound V has been prepared by reduction of the hypervalent selenium compound of 3 (6) bearing two I-Se-I groups with elemental tellurium. In V, the [(C(5)H(7)N(2)Se-)(2)](2+) cation is balanced by I(3)(-) and half I(4)(2-) anions. The structural data show that all the cations are very similar, with Se-Se bond lengths ranging from 2.409(2) to 2.440(2) Å. FT-IR and FT-Raman spectra of I-VI allow one to identify two bands around 230 +/- 10 and 193 +/- 5 cm(-1) that are common to all compounds. These bands are generally strong in the FT-Raman and weak in the FT-IR spectra and should contain a contribution of the nu(Se-Se) stretching vibration. The spectra are also in good agreement with the structural features of the polyhalide anions present in the crystals. Crystallographic data are as follows: I is monoclinic, space group P2(1), with a = 9.849(6) Å, b = 11.298(5) Å, c = 7.862(6) Å, beta = 106.44(2) degrees, Z = 2, and R = 0.0362; II is monoclinic, space group P2(1), with a = 8.063(6) Å, b = 11.535(5) Å, c = 10.280(5) Å, beta = 107.13(2) degrees, Z = 2, and R = 0.0429, III is monoclinic, space group P2(1)/n, with a = 10.431(7) Å, b = 18.073(5) Å, c = 11.223(6) Å, beta = 100.76(2) degrees, Z = 4, and R = 0.0490; IV is monoclinic, space group P2(1)/n, with a = 10.298(5) Å, b = 18.428(7) Å, c = 11.475(6) Å, beta = 104.10(4) degrees, Z = 4, and R = 0.0300; V is triclinic, space group P&onemacr;, with a = 7.456(6) Å, b = 11.988(5) Å, c = 12.508(5) Å, alpha = 79.32(2) degrees, beta = 85.49(2) degrees, gamma = 80.62(2) degrees, Z = 2, and R = 0.0340.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have