Abstract
Nickel–silicon carbide composites were produced using 1 μm and 50 nm size powders from a conventional Watt's bath using tetra methyl ammonium hydroxide as the surfactant. Sediment codeposition technique with horizontal electrodes was used. The effect of silicon carbide concentration and bath operating parameters on the volume percents and deposition rates of coatings obtained with the two different particles was studied. Substantial improvements in mechanical properties such as hardness, wear resistance, scratch resistance and roughness were obtained with the nanocomposite material, as compared with composites containing microsized particles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.