Synthesis and tribological properties of AA5052-base insitu composites

Abstract

It is important to optimize the properties of a material for a particular application, hence, to find the suitable material for tribological applications, the wear and friction behaviour of AA5052 in situ composites with different kind of reinforcements have been investigated. For present study, three in situ formed composites have been produced with different reinforcements namely Al3Zr, ZrB2 and combination of both (Al3Zr + ZrB2) by direct melt reaction (DMR) technique. The as-cast composites and base alloy have been characterized by X-ray diffraction (XRD), optical microscopy, electron microscopy, tensile testing, hardness and dry sliding wear and friction tests. XRD results indicate the successful formation of second phase reinforcement particles in all composites. Wear test results indicate that the cumulative volume loss increases with an increase in sliding distance while coefficient of friction shows a fluctuating tendency, whereas with increasing applied load, wear rate shows an increasing trend while coefficient of friction shows decreasing trend. The variation of wear rate with composites indicates that the composite with multiple reinforcement (Al3Zr + ZrB2) has lowest wear rate among all as-cast composites and base alloy, while coefficient of friction is higher. The responsible mechanisms concerned with wear and friction results have been discussed in detail with the help of the observation on worn surface analysis by scanning electron microscope (SEM) and 3D-profilometer. All tribological results have been correlated with the microstructural properties, strength parameters and bulk hardness of the composites.