Abstract

Tungsten-doped VO2 thin films have been synthesized by a modified sol–gel process and followed by a post annealing. Vanadium pentoxide and tungstic acid as raw materials with the addition of hydrogen peroxide, concentrated hydrochloric acid (catalyst) and oxalic acid used as reducing agent were reacted in isobutanol. Finally, the uniform sol of vanadyl oxalate in isobutanol solvent was obtained as precursor. Detailed study suggested that W doped in VO2 introduces additional electron carriers and induces the formation of V3+. Post annealing under vacuum promotes the releasing of chemical stress and generates oxygen vacancies in the samples. Temperature dependent transmittance study revealed that the releasing of chemical stress and deliberately introducing oxygen vacancies in W-doped VO2 films have positive effects on enhancing its switching ability in the infrared transmittance as the metal-insulator transition (MIT) occurs. The largest switching of transmittance was obtained about 48% in the infrared range at 43 °C in 1.5%W doped VO2 films, which is significantly larger than the reported ones. The findings in this work open a new way to synthesize the novel and thermochromic W doped VO2 films with facility and low cost. Therefore, it has extensive application to construct smart windows and electronic devices.

Highlights

  • Vanadium dioxide has attracted widespread interest since the discovering of its metal-insulator transition (MIT) in 1959s1

  • Infrared light would go through VO2 films mostly whereas it would be reflected above 68 °C with the same transmittance of visible light

  • These results demonstrated that employing isobutanol Sol to produce VO2 films has prominent advantages

Read more

Summary

Preparation of precursor solution

28 mg, 42 mg, and 56 mg H2WO4 were dissolved in 3 mL 30 wt% H2O2 by ultrasound respectively and the three transparent solutions were obtained. These results demonstrated that employing isobutanol Sol to produce VO2 films has prominent advantages. Hysteresis loops were obtained by collecting the transmittance of films at a fixed wavelength (2500 nm) at approximately 2 °C intervals in the temperature range of 24–90 °C

Results and Discussions
Conclusion
Author Contributions
Additional Information
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.