Abstract
Low friction thermally sprayed polymer-steel coatings for high contact pressure rolling/sliding systems were developed using high-energy plasma spraying. Polymers were applied as a thermally sprayed thin film (75–100 µm) over a thicker (250–750 µm) thermally sprayed steel coating. Twin roller rolling/sliding tests were performed at 5 and 35% creep and contact loads of 1700 N on a 5 mm contact face. A lower coefficient of friction (0.10–0.15) with increased durability, compared with that of an AISI 1080 steel thermally sprayed coating (coefficient of friction of 0.46), was observed under these rolling-sliding contact conditions. The polymer’s ability to control friction and wear stems from the mechanical anchoring of the polymer film to the rough surface of the steel coating. The polymer film was characterized by scanning electron microscopy and Fourier transform infrared analysis.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
