Abstract
Solvent engineering offers fine control over the photovoltaic efficiency, film morphology, and crystallization quality of perovskite films and also enables to optimize light transmittance and absorbance in solar cell applications. In the present work, the band gap and reflectance were reduced through solvent engineering. We found that perovskite thin films produced using DMF (Dimethyl form amide) solvent had a band gap that was 0.24 eV less than those produced using IPA (Isopropyl Alcohol) solvent. Perovskite thin films produced using DMF solvent also exhibited considerably lower solar spectrum reflectance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callSimilar Papers
More From: International Journal of Engineering Applied Sciences and Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
