Synthesis and characterization of Zn-In-S composites for photocatalytic benzyl alcohol oxidation and nitrobenzene reduction

Abstract

Photocatalytic transformation of organics is a promising alternative to conventional synthetic methodologies. ZnIn2S4 is active in photocatalytic redox reactions, but its performance is hindered by fast charge carrier recombination, and optimizing its properties through synthesis or modification is complicated. Herein, Zn-In-S based composites were prepared via a facile solvothermal method by varying the ratio of sulfide precursor (TAA) with a fixed Zn/ In molar ratio of 1: 2. The phase composition of the obtained materials depends on the amount of TAA. At lower ratios, composites consisting of crystalline In(OH)3 and unknown ZnxInySz phase were formed. Pure-phase ZnIn2S4 was obtained when the feed molar ratio of zinc and TAA was 1: 6 or higher. The photocatalytic oxidation of benzyl alcohol (BA) and reduction of nitrobenzene (NB) in a coupled system were applied to evaluate the activity of Zn-In-S-based composites. Under visible light irradiation, the ZnxInySz/ In(OH)3 composite (ZIS14) synthesized with a molar ratio of Zn to TAA of 1: 4 exhibited boosted and optimal performance compared to the bare ZnIn2S4 and other samples. After 5 hours of irradiation, the BA conversion and benzaldehyde (BAD) yield were 57 % and 55 %, respectively, and the NB conversion and aniline (AN) yield were 70 % and 35 %, individually, outperforming previous studies under similar experimental conditions. This work not only elucidates the photoredox process of BA and NB in one system, but also has significant implications for understanding the complex hydro/solvothermal processes involved in the fabrication of multicomponent sulfides.