Abstract
Abstract Carbon foams were prepared by carbonization process without additional stabilization process after manufacturing carboxymethyl cellulose (CMC) composites using a facile electron beam irradiation (EBI) method. A gel fractionation technique was used to study cross-linking degree of infusible structure in the produced CMC composite materials. We observed an increase in cross-linking with increasing CA concentration and EBI doses between 20 kGy and 80 kGy. The CMC composite prepared using 4 wt% CA and 80 kGy EBI represents the highest gel fraction value of ∼98%, showing the highest carbon yields and compressive strength due to the increase of cross-linked parts in carbon foam obtained from these CMC composites, which lowers break defects after carbonization. In addition, available surface area was estimated via Brunauer-Emmett-Teller analysis of the carbon foam samples. The carbon foam produced from the CMC composite treated with 4 wt% CA via 80 kGy resulted in highest specific surface area of 372.06 m2/g and adsorption pore size of 2.20 nm indicating greater interaction between gas and the carbon atoms.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
