Abstract
The investigation of bulk Cr 2AlC ceramic fabricated by Spark Plasma Sintering (SPS) from coarse powders (CAC10) and fine powders (NCAC10) in the temperature range of 1100–1400 °C was carried out. The XRD results indicate that Cr 2AlC, as major phase, always appears with minor and trace amount of Cr 7C 3 and Cr 2Al respectively in both NCAC10 and CAC10 samples and the amounts of later two phases decrease with increase in temperature. However, the Cr 2AlC phase content in NCAC10 is higher than that of CAC10 sintered at the same temperature. The micrographs of back-scattered SEM show that grains with smaller size and pores with fewer amounts appear in SPSed NCAC10 in comparison to that of CAC10. As consequence, the higher hardness (5.6 GPa) of NCAC10 than that (3.9 GPa) of CAC10 was obtained. The patterns of XRD, microstructure and hardness of samples HPed at 1400 °C for the same composition were also presented for comparison.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
