Abstract
Deep carbonate rock oil and gas reservoir is an important support for increasing oil and gas storage and production at present. The environment of ultradeep and ultrahigh-temperature reservoirs has put forward higher technical requirements for reservoir modification acid technology. Moreover, gelling acid is the main acid solution for high-temperature reservoir acidizing transformation, with a temperature resistance of no more than 180 °C, and the gelling agent is one of the key factors restricting its high-temperature resistance performance. In this paper, AM, AMPS, DMDAAC, and NVP were used as monomers, oxidants, and reducing agents to prepare a high-temperature-resistant polymer gel through polymerization. At the same time, microcapsules were prepared by in situ polymerization using epoxy resin as the wall material. The indoor performance evaluation results indicate that the gelling agent is easily soluble in high-concentration acid solution and has good viscosity increasing effect. At 180 °C and 170 s-1 shear rate, 0.8% mass fraction of the gelling agent was dissolved in 20% mass fraction of hydrochloric acid. After shearing for 60 min, the viscosity remained at about 22.45 mPa·s, demonstrating good temperature resistance and shear resistance, and its performance was superior to existing commonly used gelling agent products.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
