Synthesis and characterisation of silica–carbon nanotube hybrid microparticles and their effect on the electrical properties of poly(vinyl alcohol) composites

Abstract

Hybrid silica–carbon nanotube (CNT) particles with a radial symmetry were produced by the growth of nanotubes onto spherical, mesoporous silica gel particles using the floating catalyst chemical vapour deposition (FC-CVD) method. Characterisation of the hybrid particles, using electron microscopy, Raman spectroscopy and thermogravimetry showed the geometry and porosity of the silica particles to influence the alignment and density of the CNTs produced. CNT growth initiated in the pores of the gel particles and three hours of CVD growth were required to get extensive surface coverage. In the early stages of growth, the reactants diffused inside the mesoporous silica and consequently the CNTs grew mainly within the silica gel rather than on the surface. Some indication of catalyst templating was observed within the smaller (<10nm) pores, but this templating did not result in aligned CNTs. Composite films of hybrid silica–CNT particles in poly(vinyl alcohol) were cast and their impedance measured. An electrical percolation threshold of 0.62wt.% was found for the hybrid particles, of which 0.20wt.% were CNTs.