Synergistic effect of Ti3C2Tx MXene/PAN nanofiber and LLZTO particles on high-performance PEO-based solid electrolyte for lithium metal battery

Abstract

Solid polymer electrolytes (SPEs) have been considered the most promising separators for all-solid-state lithium metal batteries (ASSLMBs) due to their ease of processing and low cost. However, the practical applications of SPEs in ASSLMBs are limited by their low ionic conductivities and mechanical strength. Herein, we developed a three-dimensional (3D) interconnected MXene (Ti3C2Tx) network and Li6.4La3Zr1.4Ta0.6O12 (LLZTO) particles synergistically reinforced polyethylene oxide (PEO)-based SPE, where the association of Li+ with ether-oxygen in PEO could be significantly weakened through the Lewis acid-base interactions between the electron-absorbing group (Ti–F, −O–) of Ti3C2Tx and Li+. Besides, the TFSI− in lithium salts could be immobilized by hydrogen bonds from the Ti–OH of Ti3C2Tx. The 3D interconnected Ti3C2Tx network not only alleviated the agglomeration of inorganic fillers (LLZTO), but also improved the mechanical strength of composite solid electrolyte (CSE). Consequently, the assembled Li||CSE||Li symmetric battery showed excellent cycling stability at 35 ℃ (stable cycling over 3000 h at 0.1 mA cm−2, 0.1 mAh cm−2) and −2 ℃ (stable cycling over 2500 h at 0.05 mA cm−2, 0.05 mAh cm−2). Impressively, the LiFePO4||CSE||Li battery showed a high discharge capacity of 145.3 mAh/g at 0.3 C after 300 cycles at 35 ℃. This rational structural design provided a new strategy for the preparation of high-performance solid-state electrolytes for lithium metal batteries.