Synchronized switch harvesting applied to self-powered smart systems: Piezoactive microgenerators for autonomous wireless receivers

Abstract

This paper introduces the conceptual architecture of a fully integrated, truly self-powered structural health monitoring (SHM) scheme. The challenge here is to power an array of numerous distributed actuators and sensors as well as wireless data transmission modules without recurring to heavy and costly wiring. Based on microgenerators which directly convert ambient mechanical energy into electrical energy, using the synchronized switch harvesting (SSH) method, the proposed solution allows avoiding the periodic replacement or reloading of batteries. This addresses environmental and economic issues at the same time, knowing that such elements are heavy, polluting and might be installed in rather inaccessible locations. Indeed, especially in airborne structures saving weight and maintenance cost is of priority importance. Previous work showed that such microgenerators provide a stand-alone power source, whose performances meet the requirements of autonomous wireless transmitters (AWTs) that comprise an acoustic Lamb wave's actuator and a radio frequency (RF) emitter (D. Guyomar, Y. Jayet, L. Petit, E. Lefeuvre, T. Monnier, C. Richard, M. Lallart, Synchronized switch harvesting applied to self-powered smart systems: Piezoactive microgenerators for autonomous wireless transmitters, Sens Actuators A: Phys. 138 (1) (2007) 151–160, doi:10.1016/j.sna.2007.04.009). Following this work, the present contribution presents a further step towards the integration of the SHM technique. It shows the ability of our microgenerators to provide enough energy to give logical autonomy to each self-powered sensing node, named autonomous wireless receiver (AWR), and thus to provide some local (decentralized) pre-processing ability to the SHM system. A preliminary design of the device using off-the-shelf electronics and surface mounted piezoelectric patches will be presented. Since the existence of a positive energy balance between the harvesting capabilities of the SSH technique and the energy requirements of the proposed device will be proved, the system formed by the combination of the AWR with the previously developed AWT, is a proof of concept of truly self-powered smart systems for damage detection in simple structures, setting apart application-specific optimization or miniaturization concerns that will be addressed in future works.