Abstract
Simulation of thick-walled part produced by standard injection molding (IM), gas-assisted injection molding (GAIM) and microcellular injection molding (MuCell) for two plastic types: ABS and POM using Moldex3D R15 software. It was found high reducing mass and reducing cooling times and decreasing sink mark, volumetric shrinkage and warpage deformations of parts analyzed by GAIM and MuCell compared to IM.
Highlights
The versatility and universality of polymer materials injection technology have determined its rapid development
In addition to standard injection molding technique, different variants have been developed and implemented, which has been comprehensively described by Bociąga [1, 2]
Development of injection techniques entails the progress in commercial programs for computer simulation of manufacturing processes
Summary
Gabriela Kopeć – Politechnika Rzeszowska, Zakład Kompozytów Polimerowych, Rzeszów, Polska. Simulation of thick-walled part produced by standard injection molding (IM), gas-assisted injection molding (GAIM) and microcellular injection molding (MuCell) for two plastic types: ABS and POM using Moldex3D R15 software. It was found high reducing mass and reducing cooling times and decreasing sink mark, volumetric shrinkage and warpage deformations of parts analyzed by GAIM and MuCell compared to IM.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have