Abstract

Artificial light at night is considered a major threat to biodiversity, especially for nocturnal species, as it reduces habitat availability, quality, and functionality. Since the recent evolution in light technologies in improving luminous efficacy, developed countries are experiencing a renewal of their lighting equipment that reaches its end-of-life, from conventional lighting technologies to light emitting diodes (LEDs). Despite potential cascading impacts of such a shift on nocturnal fauna, few studies have so far dealt with the impact of the renewal of street lighting by new technologies. Specifically, only one study, by Rowse et al.2016, examined the effects of switching from widely used low pressure sodium (LPS) lamps to LEDs, using bats as biological models. This study was based on a before-after-control-impact paired design (BACIP) at 12 pairs in the UK, each including one control and one experimental streetlight. If Rowse et al. 2016 showed no effect of switching to LEDs streetlights on bat activity, the effects of respective changes in light intensity and spectrum were not disentangled when testing switch effects. Here, we conduct a retrospective analysis of their data to include these covariates in statistical models with the aim of disentangling the relative effects of these light characteristics. Our re-analysis clearly indicates that the switches in spectrum and in intensity with replacement of LPS with LED lamps have significant additive and interactive effects, on bat activity. We also show that bat activity and buzz ratio decrease with increasing LED intensity while an opposite effect is observed with LPS lamps. Hence, the loss or the gain in bat activity when lamp types, i.e., spectrum, are switched strongly depends on the initial and new lamp intensities. Our results stress the need to consider simultaneously the effects of changes in the different lights characteristics when street lighting changes. Because switches from LPS to LED lamps can lead to an increase in light intensity, such technological changes may involve a reduction of bat activity in numerous cases, especially at high LED intensities. Since we are currently at an important crossroad in lighting management, we recommend to limit LED intensity and improve its spectral composition toward warmer colors to limit potential deleterious impacts on bat activity.

Highlights

  • Light pollution induced by the widespread use of artificial light at night (ALAN) is a global pressure on the ecosystem, affecting 23% of the global land surface (88% of Europe [1]) and expandingDiversity 2020, 12, 165; doi:10.3390/d12040165 www.mdpi.com/journal/diversityDiversity 2020, 12, 165 at an annual rate of 6% worldwide [2]

  • When the lamp type effect was modeled using power as the covariate, we found that light emitting diodes (LEDs) lamps increased the total bat activity, the Nyctalus spp

  • Lights and LED lights placed as intercept

Read more

Summary

Introduction

Light pollution induced by the widespread use of artificial light at night (ALAN) is a global pressure on the ecosystem, affecting 23% of the global land surface (88% of Europe [1]) and expandingDiversity 2020, 12, 165; doi:10.3390/d12040165 www.mdpi.com/journal/diversityDiversity 2020, 12, 165 at an annual rate of 6% worldwide [2]. Light pollution induced by the widespread use of artificial light at night (ALAN) is a global pressure on the ecosystem, affecting 23% of the global land surface (88% of Europe [1]) and expanding. As ALAN alters the natural periodicity of day and night, it can disrupt the circadian and seasonal rhythms of both diurnal and nocturnal species. This pressure can affect individual fitness, sexual selection, and reproductive success [3,4,5]. A current major challenge in land-use planning involves designing outdoor lighting strategies that save energy and reduce CO2 emissions while limiting negative effects on biodiversity [2]. LEDs have a high luminous efficacy (i.e., amount of energy needed to produce visible light in lumen per watt), and offer great opportunities to save energy and limit

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call