Swift Quantification of <i>Fenofibrate</i> and <i>Tiemonium methylsulfate</i> Active Ingredients in Solid Drugs Using Particle Induced X-Ray Emission

Abstract

The quantification of active ingredients (AI) in drugs is a crucial and important step in the drug quality control process. This is usually performed by using wet chemical techniques like LC-MS, UV spectrophotometry and other appropriate organic analytical methods. However, if the active ingredient contains specific heteroatoms (F, S, Cl…), elemental IBA like PIXE and PIGE techniques, using small tandem accelerator of 1-2 MV, can be explored for molecular quantification. IBA techniques permit the analysis of the sample under solid form, without any laborious sample preparations. In this work, we demonstrate the ability of the Thick Target PIXE technique for rapid and accurate quantification of both low and high concentrations of active ingredients in different commercial drugs. Fenofibrate, a chlorinated active ingredient, is present in high amounts in two different commercial drugs, its quantification was done using the relative approach to an external standard. On the other hand, Tiemonium methylsulfate which exists in relatively low amount in commercial drugs, its quantification was done using GUPIX simulation code (absolute quantification) The experimental aspects related to the quantification validity (use of external standards, absolute quantification, matrix effect,...) are presented and discussed.