Swelling pressure characteristics of compacted Chinese Gaomiaozi bentonite GMZ01

Abstract

Gaomiaozi bentonite (GMZ01) has been decided upon as the first option for use as buffer/backfill materials in the deep disposal of high-level radioactive waste in China. The basic functions of the materials used in the waste repositories request among others a sufficient swelling pressure and low hydraulic conductivity in order to provide long-term stability to the barrier system under environmental pressure and behavior of the waste loads. As such, it is necessary to investigate the influence of initial dry density on the swelling properties of Gaomiaozi bentonite (GMZ01) in order to achieve better design of buffer/backfill materials. In this study the swelling pressure of GMZ01 has been studied and analyzed by multi and one-step wetting constant volume tests with five different dry densities (1.15, 1.35, 1.50, 1.60 and 1.75mg/m3). Results show that swelling pressure changes with time nonlinearly, while there is a linear relationship between time/swelling pressure and time. Curves of swelling pressure and the amount of absorbed water varying with time can be classified into typical phases. For the GMZ01 tested here, the initial dry density is an important factor influencing the swelling pressure. The results show that there is an exponential relationship between swelling pressure and dry density. Moreover, comparison was done between the experimental swelling pressure results of used GMZ bentonite in this study and other bentonites cited in literature: (i) other GMZ׳s and (ii) different types of bentonites proposed as buffer/backfill materials (i.e., MX80, Kunigel, Montigel, and Calcigel). The effect on the microstructure of the density and the wetting under the constant volume condition (after the swelling pressure test) has been investigated by studying the results of pore size distribution for GMZ01 by using the mercury intrusion porosimetry (MIP) test and the environmental scanning electron microscope (ESEM) photos. Finally, two different theoretical concepts were used to estimate the swelling pressure (the modified DDL and thermodynamics approaches). The results of the two methods show that the swelling pressure results compare relatively well with the experimental data for the GMZ bentonite.