Sustainable removal of tetracycline and paracetamol from water using magnetic activated carbon derived from pine fruit waste

Abstract

This work presents highly porous magnetic activated carbon nanoparticles (MPFRC-A) derived from pine fruit residue. The MPFRC-A were produced through a three-step process: physical activation (carbonization temperature: 110–550 °C), chemical activation (H2SO4 (0.1 N, 96%)), and co-precipitation. These nanoparticles were then used to remove tetracycline (TC) and paracetamol (PC) from water. Functionalization with Fe3O4 nanoparticles on the surface of the pine fruit residue-derived activated carbon (PFRC-A) resulted in high saturation magnetization, allowing for separation from aqueous solution using an external magnet. The MPFRC-A adsorbent was characterized by Brunauer–Emmett–Teller (BET) analysis, Fourier-transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), X-ray diffraction (XRD), and Energy-dispersive X-ray spectroscopy (EDX) analyses, In the experimental section, the effects of various factors on the adsorption process were investigated, including pH, contact time, initial pollutant concentrations, adsorbent dosage, and temperature. Based on these investigations, adsorption isotherm models and kinetics were studied and determined. The results showed that MPFRC-A exhibited a large specific surface area (182.5 m2/g) and a high total pore volume (0.33 cm3/g). The maximum adsorption capacity was achieved at pH 6 and 5 for PC and TC drugs with an adsorbent dose of 400 mg and an initial concentration of 20 mg/L at 25 °C. The study revealed that the experimental data were well-fitted by the Langmuir isotherm model (R2 > 0.98), with maximum uptake capacities of 43.75 mg/g for TC and 41.7 mg/g for PC. Outcomes of the adsorption thermodynamics shows non-spontaneity of the reaction and the adsorption process by all adsorbents was endothermic.