Abstract
The development of sustainable cooling technologies and increased concern for recycled materials will affect the reduction of greenhouse gas emissions, which primarily originate from the production industry. In this research paper, a twofold contribution to sustainability is made through the efficient application of a workpiece, obtained by recycling waste in the form of metal chips, and the machining of the obtained workpiece by using alternative cooling techniques comparing them to cutting fluids. Minimum quantity lubrication and cold compressed air cooling were selected as two sustainable, alternative cutting environments. Using Taguchi’s L9 orthogonal array, the influence of cutting speed, feed rate and cutting environment on drilling thrust force, built-up edge formation and hole deviation was observed. Using the analysis of variance method, feed rate was identified to have the highest influence on the output parameters (31%), followed by cooling and lubrication techniques (18%) and lastly by cutting speed (5%). Based on the grey relation analysis, optimal controllable factors were identified. This analysis indicated that low cutting speeds and feed rates, coupled with the MQL cutting environment, produced the lowest thrust force, deviation of hole and built-up edge formation.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
