Sustainable and photoresponse triboelectric nanogenerators based on 2D-gC3N4 and agricultural wastes

Abstract

Two bio-friendly and photoactive triboelectric nanogenerators (TENG) are introduced, employing sustainable and biocompatible materials as functional components. The TENGs utilize corn husk and coconut coir fibers as the positive layers and incorporate two-dimensional graphitic carbon nitride (g-C3N4) nanosheets as negative layers. Upon simple biomechanical forces, the optimized devices fabricated from corn husk and coconut fibers produce a maximum output voltage of 630 V and 581 V, respectively. Under short-circuit conditions, the measured current was approximately 0.79 mA for corn husk-TENG and 11.47 mA for coconut fibers-TENG. Also, the maximum output power of 131 mW and 1980 mW were achieved over a 2 × 2 cm2 area of corn husk-TENG and coconut fibers-TENG. The TENGs were also tested under blue commercial lights and UV light, and an increase of approximately 1.5 times was observed in the output voltages of both TENGs under UV light. These g-C3N4-based TENGs perform superior under UV illumination and can be used as nanogenerators and active photosensors. This paper proposes two eco-environmentally friendly and robust electronic devices for energy harvesting and photo-sensing applications based on two agricultural wastes, corn husk, and coconut coir fibers.