Surgical epicondylar axis is not orthogonal to the femoral mechanical knee axis in valgus knees with primary osteoarthritis: Three-dimensional analysis according to knee coronal alignment in 112 patients

Abstract

BackgroundDuring total knee arthroplasty (TKA), most surgeons align the femoral component along the surgical epicondylar axis (SEA) considering it as orthogonal to the femoral mechanical axis. However, it is still unclear how SEA coronal alignment varies according to the native coronal knee alignment. The main goal of this study was to analyze the SEA orientation according to the native coronal knee morphotype. MethodsA total of 112 patients underwent a three-dimensional (3D) -planning-based TKA. The SEA was then determined by locating the epicondyles on 3D models. The 3D femoral and tibial mechanical axes were marked and the femoral (FMA) and tibial (TMA) mechanical angles were measured. The native HKA angle was measured as FMA + TMA. The SEA orientation angles were measured in the coronal (SEA-α) and axial (SEA-β) plane. SEA orientation was compared between the valgus, neutral, and varus knees. ResultsThe mean SEA-α angle was 90.2 ± 3° and the mean axial SEA-β angle was 92.2 ± 1.3°. The SEA-α angle was significantly higher in the valgus group compared with the neutral group (92.3 ± 2.9°, 90 ± 2.9°, P = 0.0009) whereas there was no significant difference in the SEA-α angle between the varus and the neutral group (89.7 ± 2.3°, 90 ± 2.9°, P = 0.32). ConclusionsIn contrast to the neutral and varus knees, the SEA was not orthogonal to the femoral mechanical axis in patients undergoing TKA for primary osteoarthritis. Our results suggest adapting the coronal alignment of the femoral component during TKA, while maintaining an average 2° valgus in valgus knees. By contrast, with varus and neutral knees, our data support the use of a mechanical alignment.