Year-end Sale % OFF 
Abstract
Abstract Carbon-fiber-reinforced PEEK composites (APC 2, ICI plc) were plasma treated for adhesive bonding. This was done in a microwave plasma in argon or oxygen. An epoxy-based film adhesive (AF 191, 3M) was employed for adhesive bonding (1 h curing at 175°C, 30 N/cm2). Both plasma treatments resulted in a high level of lap shear strength (Ar: > 40 MPa, 25°C). The environmental behaviour (42 d, 70°C hot water) of the adhesively bonded composites has also shown that good bonds could be obtained. Regarding the stability of the freshly-treated surfaces against exposure to the surrounding atmosphere only a small decrease in lap shear strength was observed. After storage for 4 weeks in air the strength was still almost 85% of that when the bonding was done directly after the treatment. ESCA measurements revealed an increase in carbon-oxygen groups by the plasma treatment and a strong cleavage of the PEEK chemical structure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
