Surface Roughness, Dynamic Wettability, and Interphase of Modified Melamine Formaldehyde-Based Adhesives on Jabon Wood.

Abstract

Listen

Translate article

The surface roughness and wettability of wood are critical aspects to consider when producing laminated wood products with adhesive applications. This study aims to investigate the surface roughness and dynamic wettability of Jabon wood in the presence of melamine formaldehyde (MF)-based adhesives. Commercial MF adhesives (MF-0) and modified MF adhesives (MF-1) were applied to Jabon wood, which includes tangential (T), radial (R), and semi-radial (T/R) surfaces. The surface roughness of Jabon wood was assessed using a portable stylus-type profilometer. The low-bond axisymmetric drop shape analysis (LB-ADSA) method was employed to identify the contact angle (θ) of the MF-based adhesives on Jabon wood. The wettability was determined by evaluating the constant contact angle change rate (K value) using the Shi and Gardner (S/G) model. Dynamic mechanical analysis (DMA) was employed to investigate the viscoelastic characteristics of the interphase analysis of the wood and MF-based adhesives. The roughness level (Ra) of the Jabon board ranged from 5.62 to 6.94 µm, with the T/R having a higher level of roughness than the R and T. MF-0 exhibited a higher K value (0.262-0.331) than MF-1 (0.136-0.212), indicating that MF-0 wets the surface of Jabon wood more easily than MF-1. The wood-MF-0 interphase reached a maximum stiffness of 957 N/m at 123.0 °C, while the wood-MF-1 had a maximum stiffness of 2734 N/m at 110.5 °C. In addition, the wood-MF-0 had a maximum storage modulus of 12,650 MPa at a temperature of 128.9 °C, while the wood-MF-1 had a maximum storage modulus of 22,950 MPa at 113.5 °C.