Surface roughness and color stability of 3D printed temporary crown material in different oral media (In vitro study)

Abstract

Aim: To evaluate the effect of different oral media (artificial saliva, carbonated orange juice and coffee) on the surface roughness and color stability of 3D printed temporary material. Methodology: Twenty one discs samples were designed using additive manufacturing technique (SLA) were divided into 3 groups and stored in artificial saliva, coffee and carbonated orange juice at 37 ℃. Surface roughness was measured before and after immersion using non-contact USB Digital microscope. Color measurements were made before and after immersions using CIE L*a*b*. Data was analyzed by ANOVA followed by Tukey’s pair-wise tests. Results: After two, three and twelve weeks of immersion period there was statistically significant difference between the three tested oral media groups regarding the surface roughness. The highest ΔE values were observed in the coffee (3.58, 4.40 and 10.35 ΔE) followed by Carbonated orange juice mean values (3.29, 3.84 and 7.18 ΔE) while the lowest color changes mean values were for A. Saliva immersed group (1.91, 2.29 and 2.98 ΔE) respectively. Conclusions: 1. All different oral media (except A.saliva) used in the present study affected the surface roughness and the color stability of Interim discs constructed using 3-D printing technique. 2. Manufacturing of interim crowns using 3-D printing technique could be used for short-term provisional restoration. 3. This study has shown a strong positive correlation between color change and surface roughness of provisional restorative material.