Abstract

In this work, a novel method of selecting the most favourable electropolishing (EP) conditions is presented as a compromise between the processing time and obtaining the lowest possible roughness value of Sa or Sq (commonly used parameters) as well as the gradual increase of parameters highlighted in this work Ssk and Sku. The results showed that the most appropriate EP charge input should be higher than 1.2 Amin cm−2 and lower than 2.3 Amin cm−2. XPS high-resolution spectra revealed that pickling and EP of the samples results in a decrease of the ratio of the iron oxides amount (at.-%) to the total amount of chromium oxides and hydroxides (at.-%) in the passive film. This ratio gradually decreases reaching the values 1.2, 1.0 and 0.7 for as-received, pickled and electropolished samples, respectively. This result demonstrates iron dissolution of the outer surface layer by pickling and EP.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.