Abstract
ABSTRACT In this research, both eco-friendly and commercially available dielectric liquid (EDM oil, EDM oil + MoS2 powders (EDP), Sunflower oil (SF), and Sunflower oil + MoS2 powders (SFP)) was adopted to carry out the small area surface modification on Ti6Al4V sheet through the micro-EDM process. Brass rod (diameter: 0.95 mm) was used as the micro-tool electrode. The quality (surface roughness (Ra, Rq, Rz), recast layer (or coating) thickness (RLT), and the micro-hardness (MH)) of the coated surfaces was tested and compared with the change of input process parameters and dielectrics. The results indicate that the maximum micro-hardness of the coated layer for differently used dielectric mediums such as EDM oil, SF oil, EDP oil, and SFP oil is 495.9 HV, 619.05 HV, 665.42 HV, and 694.02 HV, respectively. Similarly, the coated layer thickness varies within the range of 4.56 to 24.42 μm (EDM oil), 7.24 to 28.31 μm (SF oil), 5.42 to 26.84 μm (EDP oil), and 4.66 to 32.75 μm (SFP oil). EDX plots suggest transfer of tool and the dielectric material (Ti, V, Al, C, Cu, Zn, Mo, S) to the substrate surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
