Abstract
Chemical modification of the surface of low-density polyethylene (LDPE) film was performed with an aqueous solution of ammoniacal ammonium persulfate in the presence of Ni2+ ions, where the polar groups were generated on the surface of the LDPE film. The surface of the LDPE film was modified chemically with an ammoniacal solution of ammonium persulfate (1.1M) and Ni(SO4)2 (0.02M) heated at about 70°C for 3 h. The morphologies of the surfaces were studied with scanning electron microscopy and infrared spectroscopy; electron spectroscopy for chemical analysis revealed the introduction of polar groups on the surface, which improved printability and adhesion properties. © 2001 John Wiley & Sons, Inc. J Appl Polym Sci 82: 406–415, 2001
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
