Abstract
Abstract Exhaustive tests have shown that the radial rake angle has relatively little effect upon surface finish of the workpiece in face-milling operations. Cutting speed and feed per tooth determine the surface finish, i.e., the higher the speed and finer the feed, the better the surface becomes. However, if this is carried to extremes the cutter will wear rapidly.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
