Abstract
A system has been developed by the authors to attempt to measure the surface conductivity of a large high voltage gas-filled switch housing. The housing is a hollow cylinder with an internal diameter of 300 mm and has a wall thickness of 25 mm. Unlike the situation with thin films where it is possible to perform meaningful surface conductivity measurements by creating a well defined field parallel to the surface of the material, there is a problem when dealing with bulk samples in separating the current component that results from conductivity in the bulk of the specimen from the surface component which is of interest. In addition there are concerns associated with currents arising from transient volume polarisation effects close to the current sensing electrode. A custom designed measurement system was therefore developed and this paper reports on the results obtained using this system. The observed behaviour is complex with current transients observed that showed a double relaxation process, followed by an increase in the measured current, suggesting the development of a space charge within the sample arising either from a polarisation process or from the injection of space charge into the bulk or onto the surface of the sample. The implications of these processes on the measurement of surface conductivity in measurement systems for bulk samples are discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.