Abstract
This paper studies the effect of shot blasting cycle time on the surface roughness of the boom component of an excavator. Shot blasting cycle time of 8 min and 10 min did not give the required surface roughness. The suggested surface roughness for the boom component is around 50 μm and it was achieved with shot blasting cycle time of 12 min. It was also observed that the shot blasting time is directly proportional to the surface roughness of the boom component. However, beyond the cycle time of 12 min, not much variation was observed in the surface roughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
