Surface Charging on Epoxy/Al2O3 Nanocomposites Under DC Voltage Superimposed by Repetitive Pulses

Abstract

Surface charge accumulation on polymer insulating material has been recognized as an important factor for electric field distortion that results in reduction of surface flashover voltage. This paper reports on the charge accumulation behavior between a pair of finger-shaped electrodes on epoxy/Al <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sub> O <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sub> nanocomposites under dc voltage superimposed by repetitive pulses. The charge distribution was measured by means of an electrostatic voltmeter, from which the average charge density could be calculated. Effects of dc voltage, nanofiller content, and pulse voltage on charge accumulation behavior were investigated. Obtained results showed that with the increase in the filler content from 0 wt% to 5 wt%, the average charge density increased initially then appeared to decrease. The superposition of repetitive pulses on dc voltage led to a remarkable growth in charge accumulation as compared with that when only dc voltage was applied. It is suggested that the charges are originated from local gaseous ionization and/or electrode injection, which is determined by the combined voltage. The charge density is dependent upon the surface trap, which is affected by nanofiller content. The superposition of repetitive pulse is considered as a possible reason to encourage local gaseous ionization that results in enhanced accumulation of surface charge.