Abstract

In this study, surface characteristics and osteoconductivity were investigated for the micro/nanostructured oxide layers fabricated on titanium using anodic oxidation (ANO), chemical etching (Et), and hydrothermal treatment (HT). Commercially pure titanium (CP-Ti) disks were anodic-oxidized using DC-type power supply in 1 M phosphoric acid electrolyte (P-ANO group). These specimens were further chemically etched using 30% H2O2 solution at 60 °C for 10 min (P-ANO-Et group). The P-ANO-Et-HT group was fabricated by hydrothermally treating the P-ANO-Et specimens in phosphorus-containing alkaline solution at 190 °C for 8 hrs. The P-ANO group showed a porous surface that was evenly covered with micro- and sub-micro pores. The size of these pores was decreased in the P-ANO-Et group. The P-ANO-Et-HT group showed a porous surface that was covered with nano-sized crystallites. Anatase TiO2 structure was observed in P-ANO-Et-HT group. The results of XPS demonstrated that the P-ANO-Et-HT group had a well-crystallized TiC2 structure, while the P-ANO and P-ANO-Et groups had an amorphous and phosphate-containing structure. Hydrophilicity of the P-ANO-Et-HT group was the highest. After MG63 osteoblast-like cells were cultured on the specimens for 3 hrs, SEM images of the cells cultured on P-ANO-Et-HT group specimens showed low initial adhesion. However, the osteoconductivity of these specimens increased more rapidly compared to that of the micro-structured surfaces. These results could be applied to fabricate titanium implants with an optimum micro/nano-surface for enhancing their osteoconductivity.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.