Surface Activities, Foam Properties, HLB, and Krafft Point of Some n‐Alkanesulfonates (C14–C18) with Different Isomeric Distributions

Abstract

AbstractA homologue series of sodium secondary n‐alkanesulfonates (C14, C16 and C18) were obtained by photosulfochlorination process with two different reaction conditions. Different length chains with different isomeric distributions of n‐alkanesulfonates are expected to present variations in physicochemical properties. In this investigation, the relationships between their isomeric distribution and their chain length and micellar behaviors were thoroughly explored. Their CMC at different temperatures were determined using specific conductivity and surface tension measurements. Through surface tension isotherms, the surface activities (γCMC) were obtained. The surface absorption amounts (Γmax) and the molecular areas (Amin) were calculated using Gibb's equation. As expected, these surfactants exhibit good surface properties. It was shown that the CMC values increase with increasing the percentage of secondary isomers, with a surface tension decrease. It was also shown that the CMC values decrease with increasing chain length. The HLB values were calculated for each surfactant and the results obtained suggest that they are O/W emulsifiers. The foam properties of synthesized surfactants were evaluated and compared to those obtained for commercial samples. It was shown that the foamability is influenced both by the length of the hydrophobic moiety and the percentage of secondary isomers. It can be easily concluded that the C14 sulfonates show the best foaming properties independently of their isomeric distribution. The Krafft point values obtained indicate that the micellization and the surfactant solubility mainly depend on the proportion of secondary isomers and the length of hydrophobic moiety.