Abstract
The validation and testing of tritium breeding blankets concepts, which are relevant for a future commercial reactor, is one of the goals of the ITER project. To achieve these objectives, mock-ups of breeding blankets, called Test Blanket Modules (TBMs), are tested in three ITER equatorial ports. Each TBM and its associated shield form a TBM-Set that is mechanically attached to a steel Frame. A Frame and two TBM-Sets form a TBM port plug (TBM PP). In case a TBM-Set is not available, it can be replaced by a Dummy TBM, steel made only. Both the design and manufacture of TBM Frames and Dummy TBMs are fully under the responsibility of the ITER organization. This paper describes the summary of recent analysis activities to support the design of the TBM Frame and Dummy TBM, which is presently in the preliminary design phase.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
