Superplasticity Effect Demonstrated by Gas Forming Hot Bent AA5XXX Sheets into V-Shaped Trough Containing Uneven Concavities

Abstract

Using low gas pressure as a tool to form metal sheets is certainly feasible. However, the intrinsic flow properties of metal sheet are often a key factor in determining degree of formability, which has not been emphasized or explained well. Most metals, for examples aluminum alloys, can be either superplastic or non-superplastic depending on their original processing history or route (consequently, yielding suitable microstructure) and forming conditions, i.e. mostly temperature and strain rate. This superplasticity effect is clearly demonstrated by gas forming superplastic AA5083 and non-superplastic AA5052 into a V-shaped deep trough containing uneven concavities. The results show the superiority of superplastic material when harsh product standard is required.