Abstract
Extruded Mg-6 mass%Al-1 mass%Zn (AZ61) alloy was grain-refined utilizing Equal Channel Angular Extrusion (ECAE) processing. Initially, the extruded bar of the alloy was ECAE-processed 2-times at 473 K. Subsequently, it was processed 4-times at 448 K. As a result, the grains are refined to less than 1 mm and a large amount of fine Mg17Al12 compound precipitates. Subsequently, the superplastic properties of the ECAE-processed specimens were investigated. Large fracture elongations of over 300% are obtained at 423 K and 448 K, which is below Tm=2 (Tm: melting point of the alloy), at strain rates above 1 � 10 � 4 s � 1 and 1 � 10 � 3 s � 1 , respectively. That is, low temperature superplasticity occurs. Furthermore, at a high strain rate of 1 � 10 � 2 s � 1 , superplasticity occurs with the elongation of 242% and 398% at relatively low temperatures of 473 K and 523 K, respectively. In the extraordinarily elongated specimens, significant grain boundary sliding is observed with strain rate sensitivity of 0:3� 0:4. The activation energy for superplastic deformation is about 91 kJ/mol, which is close to that for grain boundary diffusion of pure magnesium. It is concluded that the superplastic deformation mechanism of the investigated alloy would be grain boundary sliding accommodated by dislocation slip controlled by grain boundary diffusion.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
