SUNSTORM 1/X-ray Flux Monitor for CubeSats (XFM-CS): Instrument characterization and first results

Abstract

SUNSTORM 1 CubeSat was launched to Sun-synchronous low Earth orbit on August 17 2021. The primary purpose of the mission is an in-orbit demonstration of X-ray Flux Monitor (XFM) instrument. XFM is an innovative solar X-ray spectrometer for measuring and characterizing solar flares, which are known to be linked to a variety of space weather phenomena. XFM represents a next generation of solar X-ray flux monitors. It is based on silicon drift detector technology, which provides several notable performance improvements over its predecessors, which are based on Si PIN detectors. Transversal electric field and lower output capacitance allow operation at much faster pulse processing shaping times, allowing the system to achieve about 10 times higher throughput without saturation while also making it less sensitive to the increase of leakage current due to high temperature and/or radiation damage. Thus, XFM instruments can cover a very wide dynamic range of solar X-ray emission from the most quiescent conditions to the strongest X-class solar flares, while maintaining good spectral resolution (<200 eV at 6 keV). The instruments are thus well suited for both X-ray flux monitoring and spectroscopic studies of the solar corona.In this paper we describe the ground characterization and evaluation of the scientific performance of the first operational XFM instrument, a CubeSat version XFM-CS on-board SUNSTORM 1, which is a satellite built in the framework of the FLY element of ESA’s General Support Technology Programme, dedicated to the early space testing of promising new technologies. We also provide an analysis of the first results obtained during the in-orbit commissioning and early operations of SUNSTORM 1. We show the comparison of the observed scientific performance of XFM-CS with the expected performance based on theoretical modeling and ground calibration results. Finally, we describe the cross calibration of the X-ray flux data from XFM-CS with the new GOES-R series GOES X-ray sensors.