Abstract

A flow mixing calorimeter has been used to measure the excess molar enthalpy HEm of gaseous (sulfur dioxide + benzene) and (sulfur dioxide + cyclohexane) at the mole fraction y = 0.5, at standard atmospheric pressure, and over the temperature range 363.15 K to 473.15 K. The measurements were analysed in terms of the virial equation of state. The cross coefficient B12 was calculated using the arithmetic mean rule for collision diameters and the rule e12 = (1 − k12)(e11e22)1/2 for the depth of the potential well. The HEm measurements on (sulfur dioxide + cyclohexane) were fitted to within experimental error by the choice (1 − k12) = 1.01 but this value did not fit the measurements on (sulfur dioxide + benzene). The difference was attributed to a specific interaction which was analysed in terms of a quasi-chemical association model in which B12 = Bns12 − (RTK12)/2. The non-specific term Bns12 was calculated using (1 − k12) = 1.01, and values of the equilibrium constant K12 were determined from the difference between the calculated and experimental excess enthalpies. A plot of ln K12 against reciprocal temperature yielded an enthalpy of formation ΔH12 of the sulfur dioxide–benzene complex and this was found to be −(8.7 ± 2) kJ mol−1. The sum of the specific and non-specific contributions is −(13.8 ± 3) kJ mol−1. As this energy is an average taken over all orientations it should be less than the binding energy of the van der Waals complex in the minimum energy configuration computed by ab initio methods. Taleb-Bendiab et al. (A. Taleb-Bendiab, K. W. Hillig and R. L. Kuczkowski, J. Chem. Phys., 1992, 97, 2996) computed an ab initio value of −12 kJ mol−1, which is smaller than our value. Grover et al. (J. R. Grover, E. A. Walters, J. K. Newman and M. G. White, J. Am. Chem. Soc, 1985, 107, 7329) used photoionisation spectroscopy and obtained −(16.7 ± 0.8) kJ mol−1, which is in better agreement.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.