Abstract

BackgroundAbundance of the commercially and ecologically important Eastern oyster, Crassostrea virginica, has declined across the US Eastern and Gulf coasts in recent decades, spurring substantial efforts to restore oyster reefs. These efforts are widely constrained by the availability, cost, and suitability of substrates to support oyster settlement and reef establishment. In particular, oyster shell is often the preferred substrate but is relatively scarce and increasingly expensive. Thus, there is a need for alternative oyster restoration materials that are cost-effective, abundant, and durable.MethodsWe tested the viability of two low-cost substrates—concrete and recycled blue crab (Callinectes sapidus) traps—in facilitating oyster recovery in a replicated 22-month field experiment at historically productive but now degraded intertidal oyster grounds on northwestern Florida’s Nature Coast. Throughout the trial, we monitored areal oyster cover on each substrate; at the end of the trial, we measured the densities of oysters by size class (spat, juvenile, and market-size) and the biomass and volume of each reef.ResultsOysters colonized the concrete structures more quickly than the crab traps, as evidenced by significantly higher oyster cover during the first year of the experiment. By the end of the experiment, the concrete structures hosted higher densities of spat and juveniles, while the density of market-size oysters was relatively low and similar between treatments. The open structure of the crab traps led to the development of larger-volume reefs, while oyster biomass per unit area was similar between treatments. In addition, substrates positioned at lower elevations (relative to mean sea level) supported higher oyster abundance, size, and biomass than those less frequently inundated at higher elevations.DiscussionTogether, these findings indicate that both concrete and crab traps are viable substrates for oyster reef restoration, especially when placed at lower intertidal elevations conducive to oyster settlement and reef development.

Highlights

  • Concrete block production procedure The concrete structures were cast in batches using four custom-made mold units: Two large and two small mold units each produce eight blocks

  • Replace any notch pieces knocked loose from runners during demolding

  • Clamping the notch piece and the runner is recommended to ensure tight fastening. 1b

Read more

Summary

Introduction

The mold units, mounted on a plywood base, are composed of runners (with attached notch pieces), side plates, and braces (Fig. S3 & S4). After each batch cured for at least 24 hours, concrete blocks were demolded, and molds were reused to produce the batch. Replace any notch pieces knocked loose from runners during demolding. When replacing a notch piece, take care to position it correctly.

Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call