Subsurface conditioning in BTA deep hole drilling for improved component performance

Abstract

When bores with high length-to-diameter ratios (l/D > 10) and large diameters (D > 40 mm) are required, usually, the Boring and Trepanning Association (BTA) deep hole drilling process is used. Common industrial applications of this process are aerospace engineering and petrol exploration, where drilled components range from landing gears and engine shafts to drill collars. Since such parts tend to be particularly costly and highly safety–critical, ensuring favorable surface integrity during drilling is crucial to guarantee their reliability and performance. This study aims to identify correlations between the BTA deep hole drilling process and the resulting surface integrity using experimental and simulative approaches. The impact of feed and cutting speed on the thermomechanical loads and the resulting surface integrity are analyzed, also taking into account the occurrence of dynamic process disturbances. Particularly, the formation of white etching layers (WEL) is investigated using well-established, conventional techniques such as optical microscopy and microhardness testing. Additionally, innovative micromagnetic methods are employed. Magnetic Barkhausen noise (MBN) analysis is qualified as a well-applicable approach for rapid, non-destructive detection of WEL. To enhance understanding of MBN analysis and increase its robustness, the underlying mechanisms, governing the magnetic behavior of the subsurface are elucidated in detail by X-ray diffraction (XRD), electron backscatter diffraction (EBSD), magnetic force microscopy (MFM) and magneto-optical Kerr effect (MOKE) microscopy. The methodology will serve as a basis for controlled subsurface conditioning in BTA deep hole drilling.