Abstract
Using YBa <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sub> Cu <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sub> O <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">7-delta</sub> (YBCO) thin films, pulsed laser deposited on 1-mm-thick LaAlO <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sub> or SrTiO <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sub> substrates, we made 4times1 pixel arrays of transition edge bolometers with separations between neighboring pixels ranging from 40 mum to 170 mum for testing purposes. We investigated the effects of the YBCO film thickness (200 and 400 nm), substrate material, and back-etching of the substrate, on the crosstalk between the pixels of the arrays. The investigation was based on the analysis of the voltage response of the dc current biased bolometers versus the modulation frequency of a near-infrared laser source. We observed that the bolometer arrays made of 400-nm-thick films had less interpixel thermal crosstalk than the 200-nm-thick films. The effect of substrate thickness on the response of the pixels was investigated by up to 500 mum back-etching of the substrates. The bolometers made on back-etched LaAlO <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sub> substrates had anomalous crosstalk response behavior, which was effective at higher modulation frequencies. In addition, we present an analytical thermal model for explaining the observed effects of the thermal crosstalk on the response characteristics of the pixels of the arrays. We report the measured response and the anticipated thermal crosstalk of the characterized bolometers'. We describe the responses based on the thermal models and discrepancies from the model's predictions
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
